Taylor 811 Series Operator's Manual page 35

Two-Function Cook Cycle Screen
The following is an example of a two-function cook cycle
screen. The two functions shown are TURN IN and
REMOVE IN.
The total cook time or REMOVE IN time is 100 seconds.
The first function is 60 seconds, and the second function
is 100 seconds. Each timing function is accumulative.
REMOVE IN is always the last part of the cook cycle.
Figure 6-34
Three-Function Cook Cycle Screen
The following is an example of a three-function cook
cycle screen. The three functions are SEAR IN, TURN
IN, and REMOVE IN.
The total cook time or REMOVE IN time is 120 seconds.
The first function is set at 30 seconds, the second
function at 60 seconds, and the third function at 120
seconds. Each timing function is accumulative. REMOVE
IN is always the last part of the cook cycle.
Figure 6-35
Operating Procedures
Standby Procedures
Whenever the grill is idle and product is not being
cooked, the upper platen should be placed in the
STANDBY position to conserve energy.
1. To place the upper platen in the STANDBY position
from the open position, press the STANDBY button
twice, waiting 1 second between button presses.
131080
The control will display GOING TO STANDBY and then
change to display STANDBY.
Note: If the Standby Alert mode is active and the alarm
is sounding, the STANDBY button must be pressed three
times, with a 1-second pause between presses. The first
press cancels the alarm and the second two presses
lower the upper platen into the Standby position.
2. To raise the upper platen to the OPEN position to
resume cooking, press the RAISE button.
131082
platen. Damage to components may result. Only use the
RAISE button to open the upper platen.
Model 811, 813, 819, 821 Series
OPERATING PROCEDURES
Figure 6-36
Figure 6-37
CAUTION! Never use force to raise the upper
14283
6
14282
6-13