Taylor 811 Series Operator's Manual page 25

Figure 6-7
Note: Contact your local Taylor distributor to purchase
the correct grill cleaning pad and holder. (See page 4-6.)
• Do rinse both sides of the release sheet with a
clean, sanitizer-soaked grill cloth to remove the
cleaner. Allow the release sheet to dry on a
clean, flat surface.
• Do rotate the release sheet daily and re-install
on opposite side than previously used (dark
color side vs. light color side).
Start-up of the Grill
Important! The lower grill surface and the upper platen
must be clean before starting these procedures.
1. Place the power switch in the ON position.
Figure 6-8
Operating Procedures
The control will display the word initialization for 5
14534
seconds and then will enter the Off mode, displaying the
message OFF. The temperature indicators will not be
illuminated. A tone will sound for 20 seconds unless the
operator presses the display screen, Raise button, or
Standby button.
2. Press an item menu key on the control to start the
grill. The grill will start heating up to the proper
temperature. The control will display the selected
menu item and indicate TOO COOL for each heat
zone. The grill temperature indicators will be
illuminated in amber while they are heating up.
14555
Note: If an ignition failure fault occurs upon start-up,
press the Raise button, Standby button, or control
screen. The control will display OFF. Refer to problem #2,
items a, b, and c of the Gas Grill Troubleshooting Guide
on page 5. After 5 minutes has elapsed, press the Item
Menu key again. If the ignition failure fault was not
resolved, please call your local Taylor service technician.
Model 811, 813, 819, 821 Series
OPERATING PROCEDURES
Figure 6-9
Figure 6-10
13732
13692
6
6-3