Table of Contents
Advertisement
Section 1
This machine is designed for indoor use only.
DO NOT install the machine in an area where
a water jet could be used to clean or rinse the machine.
Failure to follow this instruction may result in serious
electrical shock.
Air Clearance
Clearances from the grill to other surfaces are required
for adequate air circulation:
Rear:
3 inches (76 mm) minimum.
Sides:
3 inches (76 mm) to combustible
surfaces;
0 inches (0 mm) to non‐combustible
surfaces;
0 inches (0 mm) between grills in
multiple installations.
Failure to comply with these minimum
clearance requirements will hinder grill perfor‐
mance and cause damage to its components.
Electrical Connections
The QS series grills have one electrical connection.
Check the data plate on the grill for voltage, cycle,
phase and electrical specifications. Refer to the wiring
diagram, provided inside the protective control panel
door at the front of the grill, for proper power
connections. The power connection is located behind
the access line cover on the front of the grill.
In the United States, this equipment is intended to be
installed in accordance with the National Electrical
Code (NEC), ANSI/NFPA 70-1987. The purpose of
the NEC code is the practical safeguarding of persons
and property from hazards arising from the use of
electricity. This code contains provisions considered
necessary for safety. Compliance therewith and
proper maintenance will result in an installation
essentially free from hazard!
Models QS11 & QS23
To the Installer
In all other areas of the world, equipment should be
installed in accordance with the existing local codes.
Please contact your local authorities.
Stationary appliances which are not equipped with a
power cord and a plug or other device to disconnect
the appliance from the power source must have an
all-pole disconnecting device with a contact gap of at
least 3 mm installed in the external installation.
This equipment is provided with a grounding lug
that is to be properly attached to the rear of the frame
by the authorized installer. The installation location is
marked by the equipotential bonding symbol (5021 of
IEC 60417-1) on the removable panel and the frame.
The proper wire size and fused circuit should be
selected according to grill data label information.
Incoming power must be connected to the terminals
with black characters on a white background, as
shown:
1
14092
Figure 1
071102
To the Installer
Advertisement
Table of Contents
