EventSpot 1600 Q4
Multiple EventSpots (Master/Slave control)
01) Use a 3-p XLR cable to connect the EventSpots and other devices.
The pins:
02) Link the units as shown in (Fig. 05), connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third and fourth units. You can
use the same functions on the master device as described on pages 20-21 (Manual, Auto program
or Built-in programs). This means you can set your desired operation mode on the master device and
all slave devices will react the same as the master device.
Multiple EventSpots (Master/Slave control)
Ordercode: 44050
1. Earth
2. Signal (-)
3. Signal (+)
12
Fig. 05