Control Modes; One Spectral (Static Colors); One Spectral (Built-In Programs); Multiple Spectrals (Master/Slave Control) - SHOWTEC Spectral PC 1800Z IP Manual

Spectral PC 1800Z IP

Control Modes

There are 4 modes:

One Spectral (Static Colors)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Spectral is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 15 for more information about the static colors.

One Spectral (Built-in programs)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Spectral is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 16 for more information about the built-in programs.

Multiple Spectrals (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Spectral.
The pins:
04) Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX cable. Link the second, third, and fourth units.
05) You can use the same functions on the master device as described on pages 15-16 (Static colors
and Built-in programs). This means that you can set your desired operation mode on the master
device and all slave devices will react the same as the master device.
Multiple Spectrals (Master/Slave control)
Ordercode: 43553
• Static Colors (Manual)
• Built-in programs (Auto)
• Master/Slave
• DMX-512 (9CH, 9CH, 12CH, 17CH)
01) Earth
02) Signal -
03) Signal +
10
Fig. 03