Table of Contents
Advertisement
EventSpot 1600 Q4
6.3. DMX Fail
In this menu you can adjust the device's behavior in case of a DMX signal error.
01) Press the UP/DOWN buttons until the display shows Dmx Fail.
02) Press the SET button to open the menu. The display will show:
03) Press the UP/DOWN buttons to choose between the 4 options.
●
Off: The light output will be off.
●
Hold: The device will use the last properly working DMX signal, which ensures undisrupted
performance.
●
Manual: The device will activate Manual mode.
●
Program: The device will use Program mode.
04) Press the SET button to confirm your choice.
6.4. Working Time
In this menu you can increase the operating time of the battery.
01) Press the UP/DOWN buttons until the display shows Working Time.
02) Press the SET button to open the menu. The display will show:
03) Press the UP/DOWN buttons to choose between Off or 1–15.
04) If you choose Off, the EventSpot will have maximum output (normal mode).
05) If you choose 1–15, the output will reduce but the operating time will increase to a maximum of 15 h.
06) Press the SET button to confirm your choice.
6.5. DMX Sync
In this menu you can set the DMX synchronisation.
01) Press the UP/DOWN buttons until the display shows Dmx Sync.
02) Press the SET button to open the menu. The display will show:
03) Press the UP/DOWN buttons to select On or Off.
04) The Sync option is a tool which helps to keep multiple fixtures synchronized, when using them in
Master/Slave mode.
05) If you choose On, the synchronization will be active (recommended).
06) If you choose Off, the synchronization will be off.
07) Press the SET button to confirm your choice.
Ordercode: 44050
23
Advertisement
Table of Contents
