Control Modes; One Octostrip (Auto, Built-In Programs, Sound-Controlled And Static Color); Multiple Octostrips (Master/Slave Control) - SHOWTEC LED Octostrip Set MKII 100 cm Manual

LED Octostrip Set MKII 100 cm

Control Modes

There are 6 modes:

One Octostrip (Auto, Built-in programs, Sound-controlled and Static Color)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Octostrip is not connected by means of a DMX cable, it functions as a stand-alone
device. When the Octostrip is operating in Sound-controlled mode, it will react to the beat of the
background music.
04) Please see pages 18 and 21 for more information about Auto, Built-in programs, Sound-controlled
and Static Colors modes.

Multiple Octostrips (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Octostrips.
The pins:
03) Link the units as shown in fig. 04. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third, and fourth units.
04) Connect the included 8 LED strips to the Octostrip's 5-pin XLR "out" sockets.
05) You can use the same functions on the master device as described on pages 18 and 21 (Auto, Built-
in programs, Sound-controlled and Static Colors). You can set your desired operation mode on the
master device and all slave devices will react the same as the master device.
Multiple Octostrips (Master/Slave control)
Ordercode: 42232
● Auto Mode
● Built-in programs
● Sound-controlled
● Static Colors
● Master/Slave
● DMX-512, ArtNet (6CH, 8CH, 14CH, 24CH, 26CH, 50CH, 96CH, 112CH, 192CH,
208CH)
01) Earth
02) Signal -
03) Signal +
10
Fig. 04