Backside; Installation; Setup And Operation; Charging The Built-In Battery - SHOWTEC 44050 Manual

EventSpot 1600 Q4

Backside

09) Wireless DMX receiving antenna

Installation

Remove all packing materials from the
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Setup and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Charging the built-in battery

01) In order to charge the battery you need the optional charger 44052 (is not included!).
02) Turn off the power.
03) Connect the EventSpot to the charger (Fig. 04).
04) Please make sure that the battery socket from the EventSpot covers the socket from the
charger (Fig. 04).
05) Connect the charger with a PowerCON to Schuko power cable.
06) Plug the other end of the PowerCON to Schuko power cable into a proper electric power supply
socket.
07) Charge the battery (6 hours).
08) The four LED indicators from the charger will light up green when the EventSpot is fully charged.
Ordercode: 44050
EventSpot 1600 Q4. Check that all foam and plastic padding is
10
Fig. 03