Table of Contents
Advertisement
10 Camera Functions
10.1
Save and load the camera settings
The camera has the camera setting save function, and camera setting including factory default loads
function.
The camera has below two type of camera settings.
Default: The factory default settings (This setting cannot change)
UserSetX: Over writeable camera settings (X: 0 to 7)
These camera settings load from ROM to register in RAM on camera, and camera settings at register in RAM
on camera save to ROM.
The camera settings saving and loading are controllable with Parameters ("UserSetSelector",
"UserSetDefault"), and commands ("UserSetLoad", "UserSetSave") in "UserSetControl" category of
GenICam.
The details of the parameters and the functions are in the table below:
GenICam Parameters
UserSetSelector
UserSetLoad
UserSetSave
UserSetDefault
Saving Camera Settings
Camera
Settings
Selector
UserSetSelector
Setting Procedure
1. Selects "UserSetX" at "UserSetSelector"
2. Execute "UserSetSave"
STC-MBS642POE / STC-MCS642POE
Product Specifications and User's Guide
IEnumeration Type
Select "Default" or "UserSetX"
"UserSetLoad" or "UserSetSave" process for selected settings.
ICommand Type
The camera settings load from ROM to register in RAM.
ICommand Type
The camera settings at register in RAM save to ROM.
IEnumeration Type
Select which settings ("Default" or "UserSetX") load automatically when camera
power is on. This selection saves automatically.
ROM
UserSet0 to 7
ROM
Default
When executing "UserSetSave",
camera settings at register in RAM are
saved to ROM that is selected at
"User Set Selector".
Caution:
"UserSetSave" CANNOT execute when
"Default" was selected at "UserSetSelector"
No.19S210-01
36/69
Advertisement
Table of Contents
