ETC SR12D Installation Manual page 24

24
SR48D – Remove the 10-32 x 1/2" Phillips (cross) head screw, insert
the hinge into the slot and secure it by replacing the screw.
Bottom hinge
being inserted
3. Drive the narrow end of one taper pin into the bottom of the door. Set the
taper pin into the hole on the lower hinge.
SR48D lower hinge
4. Hold the door in place and insert the other taper pin, narrow end down,
through the top hinge and washer.
5. Take the Sensor beacon block, insert it through the slot on the upper left
corner of the door so the word "SENSOR" is visible on the outside of the
rack and secure it with two 6-32 x 3/8" Phillips (cross) head screws
(included).
Bottom hinge
in place
Figure 31: Attaching the SR48D bottom hinge
Door
Taper pin
[ ] or [ ]
SR12D and SR24D lower hinge
Figure 32: Installing the bottom taper pin
Taper pin
Figure 33: Installing the top taper pin
Figure 34: Installing the Sensor beacon block
Washer
Electronic Theatre Controls, Inc.