ETC SR12D Installation Manual page 37

Sensor Delta Dimming Installation Guide
Installing network connection terminals
At one end the DMX512 and ETCLink networks connect directly to the CEM
backplane of your dimmer racks. For instructions on making those network
connections, see DMX512 and ETCLink data connections on page 18.
Other connections to the networks are made through wallplate connectors
installed on the network cable.
Wallplate connectors from ETC install in standard industry backboxes. A single
wallplate connector uses a one-gang backbox. Each additional connection
increases backbox size by one gang.
ETCLink
PUSH
1-gang ETCLink
DMX512 and ETCLink wallplate connectors may be installed alone, together
or in combination with other connector types in the same backbox, depending
on other networks used in the lighting system. Wire connections from
DMX512 and ETCLink network cables are not affected by different network
combinations on the wallplate.
A 3-gang terminal
wallplate combining
DMX512 and ETCLink
with a Remote Focus
Unit connection
Figure 43: DMX512 and ETCLink with a Remote Focus Unit connector
DATA INPUT
1-gang DMX512
Figure 42: DMX512 and ETCLink wallplate connectors
DATA INPUT
DATA INPUT ETCLink
PUSH
2-gang DMX512/ETCLink
REMOTE FOCUS UNIT ETCLink
PUSH PUSH
37