Installing Rack Modules - ETC SR12D Installation Manual

28

Installing rack modules

Sensor Delta dimming and control modules are easily slid into place by hand.
Installing dimmer modules
1. Inspect each dimmer module for loosened components or other shipping
damage.
2. Slide dimmer modules into the rack. If you are installing a mix of module
types, consult the included job drawings for the correct module order.
3. Push each module into its slot until it is flush with the front of the rack.
Installing the CEM Module
1. Inspect the CEM module for loosened components or other shipping
damage.
2. Slide the CEM module into the rack.
3. Push the module into the rack until it seats into the CEM backplane.
Note: After installing the modules, secure the module safety stops in place
to prevent module removal. See Changing Installation Rack modules
on page 11 for instructions on securing module safety stops.
Electronic Theatre Controls, Inc.