Syn-Tech Systems FuelMaster FMU-2500 Classic Installation Manual page 197

FuelMaster
This ATP applies to upgrades and installations of all FMU-2500, 3000, and 3500 series Classic and Plus
Fuel Management Units (FMUs), except aviation sites (a separate Aviation ATP is available). Complete
an ATP for each site. Place a check mark (√) in the space provided for each step performed. Some
procedures will not be applicable to all installations. Mark NA for those procedures which are not
applicable. Some procedures may be repeated for multiple FMUs. Add comments and explain any
deviations on page 5.
SITE:
LOCATION:
1. SITE EXAMINATION
All site equipment is operational, and installed in accordance with the NEC (if not, explain in
Comments on page 5).
2. FMU UPGRADE (For FMU Upgrades Only). Repeat for multiple FMUs. Note deviations on page 5.
a. Verify the FMU to be upgraded is operational.
b. Retrieve transactions, unit configuration, and options from FMU to be upgraded.
c. Upgrade the FMU.
d. Use a laptop connection to:
1) Initialize FMU (commands 02, FF, 1A, 28, FE).
2) Set/verify site signature (command 38).
3) Set system type and, if necessary, lock baud rate down (command 59).
4) Restore options (various commands).
e. Using the customer's computer, upload the site configuration, authorization list, and send
pricing, as required.
3. SOFTWARE UPGRADE (For Software Upgrades Only)
a. Verify tasking is an upgrade. Customer must have an operational copy of FuelMaster
software with an existing FuelMaster
b. Disable any auto download settings and stop all services.
c. Retrieve transactions from all FMUs.
d. Retrieve and record unit configuration and options.
e. Make a copy of the customer's existing software database and save to the desktop.
f. Upgrade the customer's existing software using a local computer administrator log on.
In step g, if not prompted "Database Conversion Finished", or if other errors occurred, discontinue
upgrade and call Syn-Tech's Customer Satisfaction Center (CSC) at 800-888-9136, ext. 1500, for
assistance.
g. When the upgrade is complete, restart the customer's computer and verify the database
opens with the new software.
10/22/10
Acceptance Test Procedure (ATP)
for Upgrades and Installations of
Fuel Management Units
®
Page 1 of 5
database.
®
NOTE
®