Figure 21: Fix Bracket to Wall
a4) Attach the CPE to the bracket and tighten the screw (Figure 22).
Figure 22: Attach CPE
a5)
Proceed to
b. High-Gain CPE:
b1) Put the bracket up to the wall and mark the drilling locations (Figure 23).
Figure 23: Mark Holes for Drilling
b2) Drill two 0.5 in. (12 mm) diameter and 3.1 in. (80 mm ) d epth holes at the marked
locations on the wall.
b3) Tap the expansion bolts into the holes with a hammer.
b4) Install the bracket on the expansion and tighten the screws.
b5) Attached the CPE to the bracket and tighten the screws (Figure 24).
section
7.
19