Attaching Patient Supports - KaVo ProXam 3DQ Instructions For Use Manual

8 3D patient exposure
What to do next

8.1.2 Attaching patient supports

8.1.2.1 Attaching support bars
Steps
28 KaVo ProXam
3. Carefully pull the sensor out.
NOTE
For safety reasons, wait for at least ten seconds before you attach a sensor
again. The blue indicator light under the locking knob has to switch off first.
NOTE
The available head supports are shown in section "Head supports (option A
or B)" on page 13.
1. Insert the support bars into the holes in the patient support table.
2. Secure support bars in position by tightening the locking knobs.
Instructions for use