Setting Basic Sensor Parameters - Thermo Scientific Smart-Vue Installation Manual

Setting basic sensor
parameters
20 Smart-Vue CO and Temperature Module Installation Guide
2
1. Access end-point module settings by pressing F11 or selecting
Settings ==> Sensor settings (
screen.
Figure 16. Main sensor settings screen applies to both sensors
2. Choose a sensor in the left-hand pane (tree structure), and adjust the
specific settings (Sensor Settings tab). You should do this for all
sensors in your system.
3. Data transfer and measurement interval settings are the same for
both the CO and the temperature sensor and must be configured
2
on the first of the two (these options are grayed out on the second
sensor).
4. Adjust the data transfer period and measurement period to meet
your specific needs. Bear in mind that it takes about 3 minutes for
the CO end-point module to warm up and be ready for use.
2
Software configuration
) on the Smart-Vue Client main
Click on dials
(dots) or
double-click
Hours/Minutes
Thermo Fisher Scientific
to set