Refreshing The Module Display With A Short Press - Thermo Scientific Smart-Vue Installation Manual

Installation procedure
Refreshing the end-point
module display with a
short press
Thermo Fisher Scientific
If a receiver or repeater is within wireless range, the Smart-Vue
end-point module automatically establishes the wireless
connection, as shown in the sequence of screen shots below:

Figure 10. Smart-Vue end-point module automatic wireless setup
sequence
The end-point module begins data-logging upon startup even if it does not
connect to the wireless system. If the end-point module does connect to the
system, as shown in Figure 10, we recommend that you avoid performing a
long-press again, which consumes battery life for no reason.
You may refresh the Smart-Vue display with the latest sensor readings by
performing a short press on the end-point module's push-button.
1. Press the button briefly to update and view the current CO
2. Wait 3 seconds and press the button again to update and view the
current temperature value.
The label and units are displayed on the LCD depending on which of the
two sensors is being read.


Smart-Vue CO and Temperature Module Installation Guide
2

value.
2
15