Main Features - Thermo Scientific Smart-Vue Installation Manual

Introduction

Main features

Thermo Fisher Scientific
Figure 1. Smart-Vue wireless end-point module mounted on a
incubator, with a flat cable connected to a CO
sensor inside an incubator.
The Smart-Vue module collects and stores CO
from the connected sensor at regular intervals and transmits them to a
computer running the Smart-Vue Server/Smart-Vue Client system
management software. This software enables you to completely configure
your Smart-Vue end-point modules as well as handle alarms, alerts, and data
storage quickly and reliably.
Do not place the Smart-Vue wireless end-point module inside the incubator.
Remove the CO /temperature sensor from inside the incubator if you
2
decontaminate the incubator (which produces a heat level not supported by
the sensor).
Note: The maximum temperature the dual CO
be exposed to is 50°C.
• AC/DC-powered wireless end-point module (with back-up battery)
• CO / temperature sensor (power supplied via end-point module from
2
AC/DC power source)
• Configurable data-logging, wireless transmission and alerts
• Automatic wireless setup
• Wireless range: indoors: 25-100 meters (82-328 ft.); up to 400 meters
(1,312 ft.) with 3 repeaters
• Operating temperature range for wireless end-point module and sensor:
0°C to +50°C
• CO concentration detected from 0 – 9%
2
2
2
Smart-Vue CO and Temperature Module Installation Guide
2
/Temperature
2
and temperature readings
/Temperature sensor may
5