What is a Smart-Vue wireless end-point module?
Typical installation
Thermo Fisher Scientific
Smart-Vue end-point modules transmit remote readings and alerts to a PC
running Thermo Scientific Smart-Vue Server/Smart-Vue Client software
and equipped with a wireless receiver. The receiver may also be located
remotely from the PC on a TCP/IP receiver installed directly on an Ethernet
network. Repeaters may be used when the wireless range between the
receiver and the Smart-Vue end-point module is too great to achieve a
strong signal. Figure 4below shows these basic configurations:
Figure 4. Typical Smart-Vue wireless configurations
Note: Each Smart-Vue end-point module may only connect back to one
receiver as shown above. Any given end-point module cannot be read by
multiple receivers.
Smart-Vue end-point modules connected to CO
installed in a convenient location at room temperature.
Smart-Vue CO
and Temperature Module Installation Guide
2
detectors are generally
2
7