Basic End-Point Module Configuration - Thermo Scientific Smart-Vue Installation Manual

Software configuration
Basic end-point module
configuration
Moving the Smart-Vue
end-point module into a group
Thermo Fisher Scientific
Smart-Vue end-point modules offer a variety of data-logging, alert and
transmission options. This section describes the basic settings to get started
right away. Please see the complete Thermo Scientific Software User Manual
for more details.
1. Launch Smart-Vue Client on your computer and enter your login
name and password to continue whenever prompted. The new
Smart-Vue should be listed as shown here, where "local" refers to the
receiver and "SDP-local" refers to a generic group for new
un-configured end-point modules connected to that receiver.
Figure 12. Example with the new dual CO
module in generic "SDP-local" group
2. Press F11 or select Settings ==> Sensor settings (
when prompted.
3. You may choose to click on Modify sensor name to replace the
numeric end-point module address with a user-friendly name (e.g.,
CO sensor).
2
The name on the end-point module's LCD is refreshed every 24 hours
(maximum) to preserve battery life. Thus, name changes may not be
shown immediately, but they are taken into account in the software.
4. Create an active group by clicking on the receiver name ("local" in
this example) ==> Create group, and then enter the group name
("Group 1" in this example). Click on OK to continue.
/temperature end-point
2
Smart-Vue CO and Temperature Module Installation Guide
2
Receiver
Temporary group
Sensors
) and log in
17