Table of Contents
Advertisement
Step 6.
Remove the 2-node scalability card (see "Removing the 2-node scalability card" on page 27 for
instructions).
Step 7.
Press the blade server cover release on each side of the blade server and lift the topmost blade
server from the bottom blade server as shown in the following illustration.
Blade server
cover release
Removing the 2-node scalability card
Use this information to remove the 2-node scalability card from a blade server.
To remove the 2-node scalability card, complete the following steps:
Step 1.
Before you begin, read "Safety" on page iii and "Installation guidelines" on page 23.
Step 2.
Loosen each screw on the 2-node scalability card, using the provided 3/16" hex driver. Alternate
the loosening of each screw until both screws are removed.
Step 3.
Lift the 2-node scalability card off both blade servers and store the card in a safe place.
Secondary
BladeCenter HX5
blade server
Blade server
cover release
.
Chapter 3
Installing optional devices
27
Advertisement
Table of Contents
