Chore-Time Konavi Pullet Feeding System Installation And Operator's Manual page 28

7.Slide the Drive Tube and flat washer over the output shaft on the Power Unit, as shown in
Figure 26.
8.Continue installing Auger until the Auger reaches the Control Unit end of the feeder line.
9.Turn the Drive Tube Weldment into the Auger, then attach to the output shaft of the Power Unit, as shown in
Figure 26. Use the Driver Block to secure the auger to the Output Shaft.
10.Attach the Anchor Plate and Gearhead Assembly to the Control Unit Body using the included hardware
shown in Figure 27.
1
2
Figure 27. Attaching the Anchor Plate and Gearhead Assembly to the Control Unit Body
28
5
3
4
Figure 26.Auger Driver Components
1
2
Item
1
2
Konavi® Pullet Feeding System
Item Description
1 Drive Tube Weldment
2 Auger
3 .688 x 1.75 x .134 Washer
4 Driver Block
5 1/4-20 Socket Head Screw
notch in Drive Tube
1
Description
1/4-20 x .50 Bolt
.259 x .489 x .062 Lock Washer
Part No.
44794
6820-X
1484
4642
5083-8
Weldment
2
Part No.
1487
1667
MF2514A