Aalcbc0N - ICP DAS USA PIR-130-AC User Manual

2.18 $AALCBC0NN
Description:
This command is used to set the Sensitivity value for the PIR Sensor on a specific channel of a
specified module.
Syntax:
$AALCBC0N[CHKSUM](CR)
$ Delimiter character
AA The address of the module to be set in hexadecimal format (00 to FF)
LCB The command to set the Sensitivity value for the PIR Sensor
C The command to set the PIR Relay Output channel
0 Specifies the PIR Relay Output channel to be set, zero based. Note that as there is only
one PIR Sensor channel on the PIR-130 module, the only valid value is 0.
NN The command to set the Sensitivity value for the PIR Sensor.
The valid range is 0 to 9, where a lower value denotes a higher sensitivity, and this
value will be stored in the EEPROM.
Response:
Valid Command:
Invalid Command:
! Delimiter character to indicate that the command was valid
? Delimiter character to indicate that the command was invalid
AA The address of the responding module in hexadecimal format (00 to FF)
There will be no response if the command syntax is incorrect, there is a communication error, or
there is no module with the specified address.
Examples:
Command: $01LCBC01
Sets the Sensitivity value for the PIR Sensor on channel 0 of module 01 to 1, and the
module returns a response indicating that the command was valid.
PIR-130-AC/DC User Manual Ver. 1.4.0, 2020/07/28
!AA[CHKSUM](CR)
?AA[CHKSUM](CR)
Response: !01
54/93