Aalc7C0Nn - ICP DAS USA PIR-130-AC User Manual

2.14 $AALC7C0NN

Description:
This command is used to set the PIR Relay Output ON Time for when the PIR Sensor is triggered
on a specific module.
Syntax:
$AALC70NN[CHKSUM](CR)
$ Delimiter character
AA The address of the module to be set in hexadecimal format (00 to FF)
LC7 The command to set the PIR Relay Output ON Time for when the PIR Sensor is
triggered
C The command to set the PIR Relay Output channel
0 Specifies the PIR Relay Output channel to be set, zero based.
Note that as there is only one PIR Sensor channel on the PIR-130 module, the only
valid value is 0.
NN The command to set the PIR Relay Output ON Time for when the PIR Sensor is
triggered in hexadecimal format. This value will be stored in the EEPROM, and the
valid range is 00 to 0F.
NN Seconds
00
04
08 131
0C 1049
Response:
Valid Command:
Invalid Command:
! Delimiter character to indicate that the command was valid
? Delimiter character to indicate that the command was invalid
AA The address of the responding module in hexadecimal format (00 to FF)
There will be no response if the command syntax is incorrect, there is a communication error, or
there is no module with the specified address.
PIR-130-AC/DC User Manual Ver. 1.4.0, 2020/07/28
NN Seconds
2 01 4
16 05 33
09 262
0D 2097
!AA[CHKSUM](CR)
?AA[CHKSUM](CR)
NN Seconds NN
02 6 03
06 49 07
0A 393 0B
0E 3146 0F
Seconds
8
66
524
4194
46/93