Aalc9C0N - ICP DAS USA PIR-130-AC User Manual

2.16 $AALC9C0NN
Description:
This command is used to set the Buzzer Operation Mode for a specific channel on a specified
module.
Syntax:
$AALC9C0N[CHKSUM](CR)
$ Delimiter character
AA The address of the module to be set in hexadecimal format (00 to FF)
LC9 The command to set the Buzzer Operation Mode
C The command to set the PIR Relay Output channel
0 Specifies the PIR Relay Output channel to be set, zero based. Note that as there is only
one PIR Sensor channel on the PIR-130 module, the only valid value is 0.
NN The command to set the Buzzer Operation Mode, where:
0: The Buzzer will NOT be activated when the PIR Sensor is triggered
1: The Buzzer WILL be activated when the PIR Sensor is triggered
This value will be stored in the EEPROM.
Response:
Valid Command:
Invalid Command:
! Delimiter character to indicate that the command was valid
? Delimiter character to indicate that the command was invalid
AA The address of the responding module in hexadecimal format (00 to FF)
There will be no response if the command syntax is incorrect, there is a communication error, or
there is no module with the specified address.
Examples:
Command: $01LC9C01
Sets the Buzzer Operation Mode for channel 0 of module 01 to 1 meaning that the
Buzzer will be activated when the PIR Sensor is triggered, and the module returns a
response indicating that the command was valid.
PIR-130-AC/DC User Manual Ver. 1.4.0, 2020/07/28
!AA[CHKSUM](CR)
?AA[CHKSUM](CR)
Response: !01
50/93