Dip Switch Configuration - ICP DAS USA PIR-130-AC User Manual

1.5 DIP Switch Configuration

Protocol:
Used to specify the communication protocol to be used by the module
DIP [1]
ON:
OFF:
Configuration:
Used to specify the configuration settings for the module
DIP [2]
ON:
OFF:
Address:
Used to specify the module address when DIP [2] is set to OFF
DIP [3] ON:
OFF:
Mode:
Used to specify the Operating Mode
DIP [4]
ON:
OFF:
PIR Operation:
Used to specify the Lux level at which the sensor will activate the light when
movement is detected.
DIP [5] ON:
OFF:
PIR-130-AC/DC User Manual Ver. 1.4.0, 2020/07/28
DCON
Modbus RTU (default)
Configure the module using DCON/Modbus commands
Configure the module via DIP Switch (default)
Use Rotary Switch positions 0 to F for node addresses 176 to 191
Use Rotary Switch positions 0 to F for node addresses 160 to 175
(default)
Operating in INIT mode
Operating in Normal mode (default)
The PIR Sensor will only detect motion when the Lux level is between
0 and 200
The PIR Sensor will detect motion continuously (default)
12/93