Aalc4C0 - ICP DAS USA PIR-130-AC User Manual

2.11 $AALC3C0
Description:
This command is used to read the Active Delay Time for a specific PIR Relay Output channel on a
specified module.
Syntax:
$AALC4C0[CHKSUM](CR)
$ Delimiter character
AA The address of the module to be read in hexadecimal format (00 to FF)
LC4 The command to read the Active Delay Time for the PIR Relay Output channel
C The command to read the PIR Relay Output channel
0 Specifies the PIR Relay Output channel to be read, zero based. Note that as there is
only one PIR Sensor channel on the PIR-130 module, the only valid value is 0.
Response:
Valid Command:
Invalid Command:
! Delimiter character to indicate that the command was valid
? Delimiter character to indicate that the command was invalid
AA The address of the responding module in hexadecimal format (00 to FF)
NNNN A four-digit hexadecimal value representing the Active Delay Time in milliseconds
There will be no response if the command syntax is incorrect, there is a communication error, or
there is no module with the specified address.
Examples:
Command: $01LC3C00BB8
Sets the Active Delay Time for PIR Relay Output channel 0 of module 01 to 0x0BB8
(3000 milliseconds) and the module returns a response indicating that the command
was valid. The PIR Relay Output channel will be active for 3000 milliseconds after the
module is powered on.
PIR-130-AC/DC User Manual Ver. 1.4.0, 2020/07/28
!AANNNN[CHKSUM](CR)
?AA[CHKSUM](CR)
Response: !01
40/93