Table of Contents
Advertisement
2.10 $AALC2C0NNNN
Description:
This command is used to set the Active Delay Time for a specific PIR Relay Output channel on a
specified module.
Syntax:
$AALC3C0NNNN[CHKSUM](CR)
$
Delimiter character
AA
The address of the module to be set in hexadecimal format (00 to FF)
LC3
The command to set the Active Delay Time for the PIR Relay Output channel
C
The command to set the PIR Relay Output channel
0
Specifies the PIR Relay Output channel to be set, zero based.
Note that as there is only one PIR Sensor channel on the PIR-130 module, the only
valid value is 0.
NNNN
A four-digit hexadecimal value representing the Active Delay Time in milliseconds. The
maximum delay time is 0x0BB8 (3000 milliseconds).
Response:
Valid Command:
Invalid Command:
>
Delimiter character to indicate the command was valid
?
Delimiter character to indicate the command was invalid
AA
The address of the responding module in hexadecimal format (00 to FF)
There will be no response if the command syntax is incorrect, there is a communication error, or
there is no module with the specified address.
Examples:
Command: $01LC3C003E8
Sets the Active Delay Time for the PIR Relay Output channel of module 01 to 0x03E8
(1000 milliseconds) and the module returns a response indicating that the command
was valid. The PIR Relay Output channel will be active for 1000 milliseconds after the
module is powered on.
PIR-130-AC/DC User Manual Ver. 1.4.0, 2020/07/28
!AA[CHKSUM](CR)
?AA[CHKSUM](CR)
Response: >01
38/93
Advertisement
Table of Contents
