Aalc6C0 - ICP DAS USA PIR-130-AC User Manual

2.13 $AALC6C0

Description:
This command is used to read the Luminance Value for the PIR Sensor on a specific channel of a
specified module.
Syntax:
$AALC6C0[CHKSUM](CR)
$ Delimiter character
AA The address of the module to be read in hexadecimal format (00 to FF)
LC6 The command to read the Luminance Value for the PIR Sensor
C The command to read the PIR channel
0 Specifies the PIR channel to be read, zero based. Note that as there is only one PIR
Sensor channel on the PIR-130 module, the only valid value is 0.
Response:
Valid Command:
Invalid Command:
Ignored Command:
! Delimiter character to indicate that the command was valid
? Delimiter character to indicate that the command was invalid
AA The address of the responding module in hexadecimal format (00 to FF)
NN The Luminance Value for the PIR Sensor, which is stored in the EEPROM. The valid
range is 0 to 4, where:
0: Disabled
1: 100 Lux
2: 200 Lux
3: 500 Lux
4: 1000 Lux
There will be no response if the command syntax is incorrect, there is a communication error, or
there is no module with the specified address.
PIR-130-AC/DC User Manual Ver. 1.4.0, 2020/07/28
!AAN[CHKSUM](CR)
?AA[CHKSUM](CR)
!AA[CHKSUM](CR)
44/93