Aalc8C0 - ICP DAS USA PIR-130-AC User Manual

2.15 $AALC8C0

Description:
This command is used to read the current PIR Relay Output ON Time for when the PIR Sensor is
triggered on a specific module.
Syntax:
$AALC1[CHKSUM](CR)
$ Delimiter character
AA The address of the module to be read in hexadecimal format (00 to FF)
LC8 The command to read the PIR Relay Output ON Time for when the PIR Sensor is
triggered
C The command to read the PIR Relay Output channel
0 Specifies the PIR Relay Output channel to be read, zero based. Note that as there is
only one PIR Sensor channel on the PIR-130 module, the only valid value is 0.
Response:
Valid Command:
Invalid Command:
! Delimiter character to indicate that the command was valid
? Delimiter character to indicate that the command was invalid
AA The address of the responding module in hexadecimal format (00 to FF)
NN The PIR Relay Output ON Time value for when the PIR Sensor is triggered in
hexadecimal format. This value will be stored in the EEPROM, and the valid range is 00
to 0F.
NN Seconds
00
04
08 131
0C 1049
There will be no response if the command syntax is incorrect, there is a communication error, or
there is no module with the specified address.
PIR-130-AC/DC User Manual Ver. 1.4.0, 2020/07/28
!AANN[CHKSUM](CR)
?AA[CHKSUM](CR)
NN Seconds
2 01 4
16 05 33
09 262
0D 2097
NN Seconds NN
02 6 03
06 49 07
0A 393 0B
0E 3146 0F
Seconds
8
66
524
4194
48/93