Connect Thunderbolt Cable; Powering On And Off The Expansion Unit; Verify Hardware Connection - Magma Roben-3TX User Manual

Connect Thunderbolt Cable

Attach Thunderbolt cable into either top or bottom port on the Roben-3. Plug in Display Monitor, DVI/HDMI,
or Display. If no display will be used, you can daisy chain other Thunderbolt devices. Plug in the other end
of the Thunderbolt cable to the Thunderbolt port on the computer.

Powering On and Off the Expansion Unit

Roben-3 will automatically turns ON when the computer is turned ON. A White light located on the front
panel will shine when the expansion chassis is ON. Roben-3 will automatically turn OFF when the computer
is turned OFF or goes into Standby mode. If either end of the Thunderbolt cable is removed while the
system is ON, the expansion chassis will automatically power down.
The White light on the front of Roben-3 is not an ON (On-off push button), it simply indicates whether the
chassis is on or off. If either end of the Thunderbolt cable is disconnected, Roben-3 will automatically turn
off.

Verify Hardware Connection

Check the status of the LEDs on the Interface cards and backplane to verify good connection or link
between your host computer and expansion unit.
1. Thunderbolt™ 1 interface card: 5 solid green LEDS are illuminated and three solid green LEDs on
the backplane. For more details see
2. Thunderbolt™ 2 Interface Card: 7 solid green LEDs are illuminated and 3 solid green LEDs on the
backplane. For more details go to
"Thunderbolt™ 1 Interface
"Thunderbolt™ 2 Interface Card
Card".
".
Roben 3 |
Magma
19