Table 4-1 Lower Display Key Parameter Prompts - Honeywell DC33XB User Manual

Operation

Table 4-1 Lower Display Key Parameter Prompts

Indication
OUTPUT #1—Output value is percent; for Three Position Step control, this is
OUT
an estimated motor position when no slidewire exists.
LOCAL SETPOINT #1—Also current setpoint when using SP Ramp.
SP
LOCAL SETPOINT #2
2SP
LOCAL SETPOINT #3
3SP
RSP REMOTE SETPOINT
INPUT 1—Used only with combinational input algorithms.
1IN
INPUT 2
2IN
SLIDEWIRE POSITION—Used only with TPSC.
POS
CSP COMPUTER SETPOINT—When SP is in override.
DEVIATION—Maximum negative display is –999.9.
DEV
PIDSETX TUNING PARAMETER SET 1—Selected set for single loop or primary loop
configuration where X is either 1 or 2.
ELAPSED TIME—Time that has elapsed on timer in Hours.Minutes.
ET XX.XX
TIME REMAINING—Time that remains on timer in Hours.Minutes
TR XX.XX
SETPOINT RAMP TIME—Time remaining in the setpoint ramp in minutes.
RAMPXXXM
O SK XXXX Soak # and TIME REMAINING IN SOAK
AUXILIARY OUTPUT
AUX
SP RATE SETPOINT—Current setpoint for setpoint rate applications
SPn
BIAS—Displays the manual reset value for algorithm PD+MR.
BIA
TUNE OFF LIMIT CYCLE TUNING NOT RUNNING—Appears when Accutune is disabled.
LIMIT CYCLE TUNING RUNNING—Appears when Accutune is enabled.
TUNE RUN
RESET SP PROGRAM TO BEGINNING OF FIRST SEGMENT
ToBEGIN
40 UDC3300 Basic Model: DC33XB User Manual
Description
12/00