Precautions; Parts Identification - Optex AX-100TFR Installation Instructions Manual

1-2

PRECAUTIONS

Install the unit on a stable
surface.
Do not allow the infrared
beam from a different model
to reach the receiver.
Receiver
Transmitter
Transmitter
(different
model)
1-3

PARTS IDENTIFICATION

Cover Main unit
Cover lock screw
Back box lock screw
Removing the Back Box >>
Loosen the
1
back box lock screw.
Install the pole in a location
where sufficient stability
can be ensured.
Observe the prescribed
transmitter-receiver
distance (range) and
installation height.
AX-100TFR
Detection range: 30 m (100 ft.)
AX-200TFR
Detection range: 60 m (200 ft.)
Installation
Height
0.7 m - 1 m
(2.3 ft. - 3.3 ft.)
This symbol indicates prohibition.
Back box
Harness retainer plate
Pull
3
2
Press
Do not install the unit in a
location where trees,
leaves, or other objects
that may swing in the wind
may block the beam.
The pole size should be
43 - 48 mm
( 1.69" - 1.89").
This symbol indicates recommendation.
Chassis
Accessories
M4×20
screws: 4
Mounting plate
lock screws
U-brackets: 2
Removing the Cover >>
Loosen the
1
cover lock screw.
- 3 -
Do not install the receiver
in a location where it is
exposed to direct sunlight.
Install the unit more than 1
m (3.3 ft.) away from the
wall or fence that are
running parallel to the beam.
1 m (3.3 ft.)
M3×8
M4×30
screws: 6
screws: 4
Pole mounting
brackets: 6
Pole mounting
bracket set
Velcro tape: 2 sets
Pull
2