Setting; Function; Channel Beam Frequency Selector - Optex AX-100TFR Installation Instructions Manual

4

SETTING

4-1

FUNCTION

(All of the following switch settings are factory default.)
4-2

4 CHANNEL BEAM FREQUENCY SELECTOR

The 4 channel beam frequency selector can be used to avoid unwanted crosstalk that can occur
when using multiple photo beams for long distance or beam stacking applications.
• To select between 4 separate beam frequencies, use the switch provided.
• Make sure the receiver and transmitter that are facing each other are set to the same channel.
• More than double stacked application is not possible.
Note>>
Always switch the frequencies TWO channels apart when stacking units on top of one another. (See following example.)
The upper unit is set on channel 1 while the lower is on channel 3, channels 2 and 4 could have also been used.
a) Double stacked protection
Tr-A
Tr-B
b) Long distance protection
Tr-A Re-A Re-B
1 1
Keys>>
Tr-A= Transmitter "A"
Re-A = Receiver "A"
Monitor jack (Receiver only)
Receiver:
1, 2: Beam interruption adjustment switch
3: Battery saving timer switch
4: Intermittent output function switch
5: N.C./N.O. selection switch
Transmitter:
1: Battery saving timer switch
2: Intermittent output function switch
3: N.C./N.O. selection switch
Receiver: Alarm indicator LED
Transmitter: Power LED
Low battery LED
View finder
Vertical alignment dial
Horizontal alignment dial
1 1
3 3
Tr-B
1 1
4 channel beam
frequency selector
Re-A
Re-B
Tr-C Re-C
3 3
- 11 -
Since Receiver B may receive
the infrared beam from
Transmitter A, select the
frequencies as shown in the
figure on the left. (In the figure,
each number in the square
indicate a channel numbers.)
Since Receiver C may receive
the infrared beam from
Transmitter A, select their
frequencies as shown in the
figure on the left.