Optex AX-100TFR Installation Instructions Manual page 5

Connect the cables from the back box to the
3
wireless transmitters.
Insert the specified batteries into the back box.
4
Specified batteries
SAFT LSH20
3.6 V 13 Ah
Fix the wireless transmitters in the back box.
5
Cut the supplied Velcro tape
to an appropriate length and apply.
Install the back box onto the chassis.
7
Tighten the
back box lock screw.
Receiver-Wireless Transmitter Connection
Yellow/Yellow-white cable: For alarm
Green/Green-white cable: For low battery
Black/Black-white cable:
Transmitter-Wireless Transmitter Connection
Green/Green-white cable: For low battery
Black/Black-white cable:
• When N.O. wireless transmitters are used, see
"Using the N.O. type transmitter" in sec. "3-4" to
change the wiring.
• Use the specified batteries for the wireless
transmitters.
• Do not use batteries other than those specified.
Specified batteries:
Four LSH20 batteries manufactured by SAFT
• Do not mix batteries that have different levels of
power remaining (i.e., new and used batteries).
Not observing the above may result in an explosion,
leakage of electrolyte, emission of toxic gases or
other outcomes that may be harmful to people and
property.
Remove all batteries prior to replacing with new ones.
If this is not followed, the low battery indicator LED
will not reset and continue to flicker.
Run the cables so that they are not pinched
6
between the chassis and back box.
Lithium batteries are used.
Follow EU Battery Directive (2013/56/EU)
to dispose batteries.
- 5 -
For tamper
For tamper
Caution
Warning
Caution