Precautions; Parts Identification; Preparations; Ordering Detector Batteries - Optex AX-100 TFRi Installation Instructions Manual

1-2 PRECAUTIONS

Do not install the unit on an
unstable surface.
Do not install the unit in trees,
leaves, or other objects that
may swing in the wind and
block the beam.
Do not allow the infrared beam
from a different model to reach
the receiver.
Receiver
Transmitter
Receiver Transmitter
(another (another
detector) detector)
The pole size should be 43 -
48 mm ( 1.69" - 1.89").
This symbol indicates prohibition.
This symbol indicates recommendation.

1-3 PARTS IDENTIFICATION

Cover Main unit
Cover lock screw
Accessories>>
M4×30 screws: 4
M4×20 screws: 4
Pole brackets: 6
Mounting plate
Pole mounting bracket set
lock screws
Do not install the pole in a
location where sufficient stability
can not be ensured.
Do not install the receiver in a
location where it is exposed to
direct sunlight.
Install the unit at a height where
an object can be detected
without fail.
Install the unit at least 1 m (3.3
ft.) away from the wall or fence
that may be running parallel to
the beam.
1 m (3.3 ft.)
Back box Chassis
EN1941
BCU-4
Back box terminal
Harness retainer plate
Back box lock screw
M3×8 screws: 6
U-brackets: 2
Removing the Back Box >>
1
Loosen the
back box lock screw.
Removing the Cover >>
1
Loosen the
cover lock screw.
2

PREPARATIONS

2-1 ORDERING DETECTOR BATTERIES

Specified batteries: Four LSH20 batteries manufactured by SAFT
For information about batteries, visit the following website and
contact your local SAFT sales representative.
http://www.saftbatteries.com/Contacts/tabid/72/FP/9/FROM/PROD
UIT/Default.aspx

2-2 REGISTER WIRELESS TRANSMITTER

Before installing AX-100TFRi/200TFRi, register the INOVONICS'
wireless transmitter EN1941, which has been stored and wired in
the back box, to the wireless receiver.
The available wireless receivers by INOVONICS are shown below:
EN7285, EN4216MR and EN4232MR
The registration procedure is shown below:
The REGISTER XMITTER option on the wireless receiver allows
you to register the wireless transmitter EN1941.
1. From the INSTALL & SERVICE menu, use the Up and Down
buttons to navigate to the REGISTER XMITTER prompt. Press
the Enter button.
2. Use the Up and Down buttons to choose the point to witch you
want to register the AX-100TFRi/200TFRi (EN1941).
3. Press the Reset button that located on the EN1941, at the
RESET XMITTER prompt.
Note>>
Refer to RF receiver manual for checking the wireless signal
strength of the transmitter.
For UL/c-UL installations the signal strength shall be verified as
"good".
The wireless transmitters are compatible with he INOVONICS'
models EN7285, EN4216MR and EN4232MR RF Receiver.
Refer to the installation instrutions for the RF reciever for full
wireless installstion, compertible control panels and programming
required.
-2-
3
Pull
2
Press
2
Pull
Reset button