Before Your Operation; Precautions - Optex Smart Line Series Installation Instructions Manual

1
INTRODUCTION

1-1 BEFORE YOUR OPERATION

• Read this instruction manual carefully prior to installation.
• After reading, store this manual carefully in an easily accessible place for reference.
• This manual uses the following warning indications for correct use of the product, harm to you or other people and damage to your assets, which
are described below. Be sure to understand the description before reading the rest of this manual.
Warning
Caution
This symbol indicates prohibition. The specific prohibited action is provided in and/or around the figure.
This symbol requires an action or gives an instruction.
Warning
Caution

1-2 PRECAUTIONS

Do not install the unit on an
unstable surface.
Do not allow the infrared beam
from a different model to reach
the receiver.
Receiver
Transmitter
Receiver
(different
model)
For UL/c-UL installations ;
• Reference to UL681, Standard for Installation and Classification of Burglar and Holdup Alarm System.
• Reference to CAN/ULC-S302, ULC Standard for Installation and Classification of Burglar Alarm Systems for Financial and Commercial Premises.
Safes and Vaults, & CAN/ULC-S310, ULC Standards for Installation and Classification of Residential Burglar Alarm.
• Conduit is required for all Outdoor Use Application with Conduit Bracket Kit, Model CBR-4, employing appropriate wiring methods.
• Products to be installed within the protected premises.
Failure to follow the instructions provided with this indication and improper handling may cause
death or serious injury.
Failure to follow the instructions provided with this indication and improper handling may cause
injury and/or property damage.
Do not use the product for purposes other than the detection of moving objects such as
people and vehicles. Do not use the product to activate a shutter, etc., which may
cause an accident.
Do not touch the unit base or power terminals of the product with a wet hand (do not
touch when the product is wet with rain, etc.). It may cause electric shock.
Never attempt to disassemble or repair the product. It may cause fire or damage to the
devices.
Do not exceed the voltage or current rating specified for any of the terminals during
installation, doing so may cause fire or damage to the devices.
Do not pour water over the product with a bucket, hose, etc. The water may enter,
which may cause damage to the devices.
Clean and check the product periodically for safe use. If any problem is found, do not
attempt to use the product as it is and have the product repaired by a professional
engineer or electrician.
Do not install the pole in a
location where sufficient
stability can not be ensured.
Install the unit at a height
where an object can be
detected without fail.
Transmitter
(different
model)
Transmitter
Do not install the unit in a
location where trees, leaves, or
other objects that may swing in
the wind and block the beam.
The pole size should be
34 - 48 mm
( 1.34 - 1.89 inch).
Receiver
This symbol indicates prohibition.
-2-
Do not install the receiver in a
location where it is exposed to
direct sunlight.
[Receiver]
Install the unit at least 1 m (3.3
ft.) away from the wall or fence
that may be running parallel to
the beam.
At least 1 m (3.3 ft.)
This symbol indicates recommendation.