3-2
POLE MOUNTING
-Single set
Remove the chassis from the back box.
1
Using a screwdriver or similar tool, break the
2
knockout portion as shown.
Fix the chassis on the pole.
4
M4×30 screw
(supplied)
-Two detectors in opposing directions
Remove the chassis from the back box.
1
Using a screwdriver or similar tool, break the
2
knockout portion as shown.
Detector 1
Knockout two
locations pairing
in a horizontal line.
U-bracket
(supplied)
After mounting the chassis, wiggle the tamper
bushing with your thumb and forefinger to ensure the
tamper works properly.
Choose
a different
pair of
Detector 2
knockouts.
- 6 -
Install three pole mounting brackets on the chassis.
3
M3×8 screw
Pole mounting bracket
(supplied)
(supplied)
Take steps 3 through 6 refer to sec. "3-1" to
5
install the wireless transmitters and batteries in
the back box, and then install the back box on
the chassis.
Tighten the
back box lock screw.
Caution
Install three pole mounting brackets on the chassis.
3
Install the bracket
in the knocked-out
locations in step 2 .
Detector 1
M3×8 screw
Pole mounting
(supplied)
bracket
(supplied)
Install the bracket
in the knocked-out
locations in step 2 .
Detector 2
M3×8 screw
Pole mounting
(supplied)
bracket (supplied)