Fitting Modules On The Mounting Rail - Siemens SIMOTION C 230-2 Operating Instructions Manual

PE connection
The figure below shows the proper way of connecting the protective conductor to the mounting
rail.
Figure 5-6
5.3.2

Fitting modules on the mounting rail

Accessories
Any accessories you need for installation are in the pack with the modules. Chapter Spare parts
and accessories (Page 173) contains a list of accessories and spare parts together with the
corresponding Article Nos.
Table 5-6
Module
SIMOTION C
Signal module
(SM)
Sequence in which modules are affixed to the mounting rail
1. Power supply module
2. SIMOTION C
3. Signal module(s)
SIMOTION C
Operating Instructions, 11/2022, A5E33441428B
Protective conductor connection on the mounting rail
Module accessories
Accessories supplied
One slot number plate
Two keys (C230-2)
One labeling plate
One bus connector
One labeling plate
Configuring and installing
Explanation
For the assignment of slot numbers
The key is used to operate the mode selector for
the C230-2.
For labeling of integrated inputs and outputs of
the SIMOTION C
To provide the electrical connections between
the modules
To label the inputs and outputs on the module
5.3 Installing
87