Siemens SIMOTION C 230-2 Operating Instructions Manual page 24

Description
2.1 System overview
Distributed I/O
Table 2-2
Component
SIMOTION C
Table 2-3
Component
Programming device (PG/PC)
SIMATIC HMI device
Drive units
24
SIMOTION C with distributed I/O
Function
... is the motion control module.
• Communicates via two PROFIBUS DP interfaces with:
– Programming device (PG/PC)
– SIMATIC HMI devices
– SIMATIC S7 controllers with PROFIBUS DP interface
– SIMATIC ET 200 I/O systems
– Drive units
– Other SIMOTION controllers
• Communicates via an Ethernet interface with the programming de‐
vice (PG/PC)
• The C240 PN also communicates via the PROFINET IO interface with:
– Programming device (PG/PC) via Ethernet
– SIMATIC HMI devices
– SIMATIC S7 controllers with PROFINET IO interface
– SIMATIC ET 200 I/O systems with PROFINET IO interface
– Drive units
– Other SIMOTION controllers
Note:
All approved devices are listed in the PM 21 Catalog and in chapter I/O
modules approved for SIMOTION (Page 25).
Further components that can be connected to the SIMOTION C
Function
... configures, parameterizes, programs and tests SIMOTION.
... is used for operator control and monitoring functions. It is not an
essential requirement for the operation of a SIMOTION C.
Note:
All approved devices are listed in the PM 21 Catalog.
... convert speed setpoints into signals for controlling the motor and
supply the power required to operate the motors.
Note:
All approved devices are listed in the PM 21 Catalog.
Operating Instructions, 11/2022, A5E33441428B
SIMOTION C