Profibus Dp Interfaces - Siemens SIMOTION C 230-2 Operating Instructions Manual

Interfaces

4.4 PROFIBUS DP interfaces

Signal type
I - signal input
O - signal output
Note
You will find additional information about PROFINET in the SIMOTION SCOUT Communication
System Manual.
4.4 PROFIBUS DP interfaces
PROFIBUS DP interfaces (X8, X9)
The SIMOTION C provides two interfaces for connection to the PROFIBUS DP. Baud rates up to 12
Mbits/s are possible. Both interfaces can be operated isochronously.
If both interfaces (X8, X9) are to be operated isochronously, then they must both be configured
with the same DP cycle clock.
Alternatively, the X9 interface can be used as an MPI interface with a transmission rate up to 12
Mbits/s.
Connectable devices
The following devices can be connected to the PROFIBUS DP interfaces:
• PG/PC
• SIMATIC HMI devices
• SIMATIC S7 controllers with PROFIBUS DP interface
• Distributed I/O (e.g. SIMATIC ET 200M)
The digital inputs/digital outputs are updated in the position control cycle clock.
• SIMOTION controller
• Teleservice adapter
• Drive units with PROFIBUS DP interface (e.g. SIMODRIVE 611 universal) according to
PROFIdrive profiles / IEC61800-7.
Note
A teleservice adapter can only be connected to one of the two interfaces.
All released modules and devices are listed in the PM 21 Catalog and in chapter I/O modules
approved for SIMOTION (Page 25). This document is supplied in electronic format with
SIMOTION SCOUT.
Take note of the documentation on the individual modules or devices!
48
Operating Instructions, 11/2022, A5E33441428B
SIMOTION C