Table of Contents
Advertisement
2.1.3
Interfaces and interface parameters
2.1.3.1 Active interfaces
2.1.3.2 Interface parameters
2.1.4
IP – address
2.2
Exit
2.3
Saving parameters to a data carrier
Siemens Building Technologies
Fire Safety & Security Products
Set by enabling the PC interface (COM1-COM2: as standard; COM3-COM20 if
extra interfaces have been installed), to which the SIMATRIX is connected and
setting the relevant interface parameters. Proceed as follows to work on-line:
COM1
...
COM20
UDP/IP port 9000
LAN connection , only available with NEO V2
Off-line mode
Choose this option if there is no connection with the SIMATRIX.
If the programming software is unable to establish a connection to the SIMATRIX,
the off-line mode will automatically be selected.
The SIMATRIX will display the chosen baud rate upon start-up. The PC to which
the SIMATRIX is connected must be set to the same baud rate and other interface
parameters as the SIMATRIX.
The following parameters for communication with the SIMATRIX can be enabled
and assigned to the active interface in the programming PC:
8/ 2/ E
8/ 1/ N
8/ 1/ E
Here is shown the IP – address of SIMATRIX NEO V2.
Use the
button to close the program. If you have changed any parameters, a
Exit
notification message will appear asking you if want to save the changes.
Using the
button saves all the settings you have entered, or changes you
Save
have made to the SIMATRIX parameters, to a file on the hard disk or on floppy.
You can use any file name you want.
The file extension is set to *.dat as standard, but, like the file name, can be set to
any extension you want.
General functions
19
06.2008
Advertisement
Table of Contents
