Table Of Contents - Mitsubishi Electric MR-J4 B Series Instruction Manual

14. USING A LINEAR SERVO MOTOR
14.3.5 Operation from controller
The linear servo can be used with any of the following controllers.
(1) Operation method
For the system using the incremental linear encoder, the magnetic pole detection is automatically
performed at the first servo-on after the power-on. For this reason, when performing the positioning
operation, create the sequence which surely confirms the servo-on status as the inter lock condition of
the positioning command.
Also, some parameter settings and the home position return type differ according to the controller type.
(2) Servo system controller setting
(a) Setting precautions
The following parameters will be enabled by turning the servo amplifier power off and on again after
the controller writes the parameters to the servo amplifier.
Command
resolution
Servo amplifier
setting
Motor setting
(Note)
No.
Symbol
PA01 **STY
PC01 ERZ
PC03 *ENRS
PC27 **COP9 Function selection C-9
PL01 **LIT1
PL02 **LIM
PL03 **LID
Parameter
PL04 *LIT2
PL05 LB1
PL06 LB2
PL07 LB3
PL08 *LIT3
PL09 LPWM
PL17 LTSTS
PL18 IDLV
Unit setting
Positioning
control
Number of pulses (AP)
parameter
Travel distance (AL)
Servo system controller
Motion controller
Simple motion module
Setting item
Name
Operation mode (Note 2)
Error excessive alarm level
Encoder output pulse selection
Linear servo motor/DD motor function
selection 1
Linear encoder resolution - Numerator
Linear encoder resolution
Denominator
Linear servo motor/DD motor function
selection 2
Position deviation error detection level
Speed deviation error detection level
Torque/thrust deviation error detection
level
Linear servo motor/DD motor function
selection 3
Magnetic pole detection voltage level
Magnetic pole detection - Minute
position detection method - Function
selection
Magnetic pole detection - Minute
position detection method -
Identification signal amplitude
Q17_DSCPU
QD77MS_
Motion controller
Q17_DSCPU
Initial
value
1000h
0
0000h
0000h
0301h
1000
-
1000
0003h
0
Set the items as required.
0
100
0010h
30
0000h
0
Refer to (2) (b) of this section.
14 - 22
Model
Set content
Simple motion module
QD77MS_
Linear encoder resolution unit
MR-J4-B Linear
Automatic setting
0040h
mm