Cluster Host Server Configuration; Network Settings - Grandstream Networks IPVT10 Administration Manual

Cluster Host Server Configuration

Network Settings

The IPVT10 server supports two network adapters that can be configured based on the actual requirements. There are 5
typical network deployment Scenarios:
Scenario 1: The server is deployed on the internal network. The end-users use the service only within the internal
network. Users could only configure the internal network IP address.
Scenario 2: The server is deployed on the external network. The end-users use the service via the public network. Users
need to configure the external IP address.
Scenario 3: The server is deployed on the internal network. The end-users use the service via the public network. In this
case, users need to configure the internal IP address and NAT in the server.
Scenario 4: The server is deployed on the internal network. The end users can use the service via both internal and
external networks. In this case, users need to configure the server with both internal network and external network and
routing rules.
Scenario 5: The server is deployed on the internal network. The end users can use the service via the internal network and
limit certain external IP addresses to access the service. In this case, users need to configure the internal network, external
network, NAT, and routing rules in the server.
Options Descriptions
Parameters Description
Native Domain
Configures the domain name of the IPVT10 server.
Name
Internal Network
Configures Internal Network Adapter's parameters.
Adapter
External Network
Configures External Network Adapter's parameters.
Adapter
IPv4 Address Configures the IP Address for IPVideoTalk Portal.
Subnet Mask Configures the Subnet Mask.
Figure 15: System Information