Configure Smtp Mailbox - Grandstream Networks IPVT10 Administration Manual

5. Configure the server address and port for the target server, which is the server IP address or domain name of the 3rd party
platform, and the port number of the target server.
6. Select the "Protocol Type" for the 3rd party platform (TCP/TLS/UDP).
7. Check and choose whether 3rd party supports SRTP. If support, then use SRTP otherwise use RTP instead.
Unified platform accounts authentication: Users only need to configure 1 SIP account and password on the 3 party
platform, the IPVT10 will always use this SIP account and password authentication to access the 3 party platform.
One-to-one platform account authentication: Users need to configure multiple SIP accounts, passwords, and mapped
IPVT ID on the 3rd party platform. Only the authenticated IPVT IDs can access the 3 party platform. Users could add
multiple accounts or edit/delete the accounts.
Note
The mapped IPVT IDs have to be the existing accounts in the IPVT10 server.
8. When the configurations are done, users click to save the configuration and click on the "Deploy to server" button to apply
the changes. The server will reboot to apply the changes.
Note
Video display is supported for UCM meeting attendees.

Configure SMTP Mailbox

This Email box is used to send the meeting invitation Emails, meeting reminders, and other notifications as the Email sender. If
users do not configure this Email box, the system cannot send Emails to inform the meeting participants.
Please, refer to the following steps:
1. Login IPVT10 Web UI.
2. Click on "Service Configuration" and configure the "SMTP Mailbox" options, as shown below:
Figure 23: SIP Trunk Service Configuration – Call
rd
rd
rd