R&S SpycerBox Cell Hardware Manual page 60

Maintenance
 Backup or Recovery of the System Disk
Once the boot menu is displayed on the screen, select the USB
4.
flash drive as the boot device and then press [Enter] on your key-
board.
With this the target device has been selected. The system will now boot
from the USB and you will see a window on the screen where you can
select the DVS Rescue environment for loading:
Select DVS Rescue and press [Enter] on your keyboard.
5.
Once the loading has finished, you will see the DVS Rescue script with
its options on the screen. Your display should look similar to the follow-
ing:
--- DVS Rescue ---
1 - Backup on USB device
2 - Restore from USB device
3 - Reboot the system
4 - Poweroff the system
0 - Exit
Enter selection:
To make a backup image of your system disk and save it to the
6.
USB, press [1] and then [Enter] on your keyboard.
Afterwards a list of possible source devices will be detailed on the
screen. In a SpycerBox Cell the system drive normally will be 'sdc', but
on special systems it may also be 'sda', 'sdb', etc.
Ex factory the R&S DVS system will be delivered with 'sdc' as the default
system disk. If other configurations have been made later or on custom-
er request, this may be different.
Selecting wrong source device
Selecting the wrong source device may lead to an unwanted con-
figuration and malfunctions when the system is operating.
Continue with the following steps only, when you are able
to identify the correct source device.
Enter the name of the system disk: Type in sdc (or in other cases
7.
sda, sdb, etc.) and press [Enter] on your keyboard.
The system will now ask you to enter the image name for your backup
image to be saved. By entering the name of an already existing backup
image you can overwrite it.
Type in the name of the image you want to save to the USB and
8.
press [Enter] on your keyboard.
5-22
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH