R&S SpycerBox Cell Hardware Manual page 45

Now the hard disk has to be replaced in the next step.
Step 2: Reassembling the Hard Disk
In the next step, the disk carrier with the new disk has to be reassem-
bled in the system. Perform the following to be reassemble it in the sys-
tem:
Incorrect handling of the hard disks
Significant environmental changes, for example, altitude, voltage,
temperature, shock, vibration, etc., can damage a hard disk.
Handle hard disks with great care.
The system is designed to allow an exchange of a defective hard disk
while it is in operation (hot-swappable system). Sometimes the perfor-
mance of accesses to the respective hard disk, e.g. via software, might
be reduced during rebuild processes.
1. Unpack the new hard disk you have received from R&S DVS.
2. When standing right in front of the system, you have to cautiously
slide the hard disk back in its place on the hard disk tray.
The interfaces at the hard disk have to plug back in place on the hard
disk tray.
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH
Maintenance
 Hard Disk Maintenance
Figure 5-3: Pulling out the hard disk
5-7