Controller Module - R&S SpycerBox Cell Hardware Manual

Overview
 Overview of the Rear

2.3.2 Controller Module

The SpycerBox Cell provides on its controller module area several con-
nection possibilities such as the network ports. The following figure
shows an example configuration of the controller module area:
fixed main connector panel
Figure 2-7: Example of a controller module configuration on the SpycerBox Cell
The above layout of the controller module area is just an example. The
one at your system may differ from the figure above: The position of the
individual panels on the controller module may vary and/or other panels
may be installed, either for internal reasons or on your request.
The panels showing the Ethernet option and the Fibre Channel option in
the figures above are used for optional cards that you can order.
expansion panel for
Ethernet option
2-10
expansion panel for
Ethernet option
expansion panel for
Fibre Channel option
fixed RAID controller
Here you can configure your Ethernet op-
tion when ordering the SpycerBox Cell.
The following options are available:

Quad-port 1 Gbit/s Ethernet

Dual-port 10 Gbit/s Ethernet
For further information about this, please
see section "Variants of the
SpycerBox Cell" on page 2-2.
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH