Faceplate - R&S SpycerBox Cell Hardware Manual

Overview
 Overview of the Front
Item
operation
items
Further information about what to do in case of an alarm can be found
in section "Troubleshooting" on page A-2.

2.2.1 Faceplate

The faceplate covers the hard disks of the hard disk tray. It is built with
an integrated R&S logo which indicates the systems power-on status:
If the R&S logo is illuminated, the power is turned on; if not, the power
is turned off. The front cooling fans are build inside the faceplate.
The system must be operated only with the faceplate installed to ensure
proper cooling.
In case you have to exchange a hard disk, you can remove the faceplate
for a maximum of the time the hard disk exchange will take.
2-4
power
With the operation items the system can be controlled
(e.g. turned on or off). The power switch (first button on
top) turns the system on or off. The respective state of
the system will be indicated by the R&S DVS logo in the
middle of the faceplate (see section "Faceplate" on
page 2-4).
mute
In case of a hardware malfunction a system alarm turns
on. By pressing the mute button (below the power but-
ton), the alarm buzzer can be switched mute.
The operating system must be fully load-
ed to switch an alarm mute.
SpycerBox Cell | Hardware Guide | Version 1.0
Explanation
Rohde & Schwarz DVS GmbH