R&S SpycerBox Cell Hardware Manual page 19

Removing the faceplate
If you need access to one of the hard disks, for example, to replace it,
you just have to remove the faceplate:
To remove the faceplate, perform the following steps:
Press the darker metal button on the right side of the faceplate
1.
and keep it pressed.
2. When standing right in front of the SpycerBox Cell, pull the face-
plate with moderate but intense strength from the right side to
your direction.
Take the faceplate out of its fastening on the left side.
3.
Then you can access the hard disks of the hard disk tray (see section
"Hard Disk Tray" on page 2-6).
Fastening the faceplate
After finishing your task at hand you have to fasten the faceplate to the
R&S DVS system again. For this perform the following:
Simply put the faceplate back into its fastening at the left side.
1.
Press the faceplate with moderate but intense strength until it
2.
snaps into its fastening at the right side.
With this the task of fastening the faceplate is finished and the R&S
DVS logo in the middle of the faceplate will be illuminated again.
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH
 Overview of the Front
2
Figure 2-2: Removing the faceplate
Overview
1
2-5